Bryant Lincoln’s Energy Savings Plan (ESP) is a thorough 32 point check of your home’s heating and cooling system. Our technicians will perform the following inspection to ensure that you equipment is working at the highest efficiency possible.
Check Carbon Monoxide Level
Adjust Bypass Dampers
Clean or Replace Filters (1″ standard filter included if needed)
Tighten Electrical Connections
Evaluate Safety Controls
Measure Temperature Differences
Adjust Thermostat Calibration
Check Fan Blades for Tightness
Lubricate Fan Motor
Clean and Adjust Burners
Check Circuit Board Operation
Set Burner Adjustment
Measure Gas Output
Set Manifold Pressure
Check Defrost System (HP)
Inspect Blower Wheel
Inspect Valves
Check Flue or Venting
Check Flame Sensor
Inspect Combustion Chamber
Inspect Secondary Heat Exchanger
Test Thermocouple, Pilot, or igniter
Check Combustion Air
Check Evaporator Coil
Clean Evaporator Drain
Adjust Bypass Dampers
Clean or Replace Filters (1″ standard filter included if needed)
Tighten Electrical Connections
Measure Temperature Differences
Clean Condenser Coil
Adjust Thermostat Calibration
Check Fan Blades for Tightness
Lubricate Fan Motor
Check Start and Run Capacitors
Check Start and Run Relays
Check Refrigerant Level
Adjust Operating Pressures
Measure Voltage Differences
Measure Amperage Draw
Inspect Blower Wheel
The following inspections are made in heating check for homes with a heat pump.
Check Evaporator Coil
Check Start and Run Capacitors
Check Start and Run Relays
Check Refrigerant Level
Adjust Operating Pressures
Measure Voltage Differences
Measure Amperage Draw